Start-Up Checklist
Job Name
Employee Name
Pool Automation and Setup
Put in and start Alpha IQ electronic pool sweep. Not required for Quattro.
Yes
No
Comments
Check pool panel for correct wiring. Red, Black, Yellow, Green for com wires.
Yes
No
Comments
Connect Pool Antenna to homeowner's WIFI. Add pool to office account.
Yes
No
Comments
Clear memory w/ iAqualink App!!! in WEB section of app.
Yes
No
Comments
Check that all unions on equipment pad been hand-tightened?
Yes
No
Comments
Is pump running? Has Premier Pools Service been notified of Chem request?
Yes
No
Comments
Pull plug in Autofill basket and flush line. Clean out basket of debris. Install Autofill with 3/4in plumbers tape.
Yes
No
Comments
Check weir door, skimmer basket, and diverter valve installation.
Yes
No
Comments
Hook up lights and test. Clean J-Box if dirty.
Yes
No
Comments
Set JVA valves and test. Set Cleaner JVA (ATLAS ONLY) to 80/20 split.
Yes
No
Comments
Program Main Pump and Water Feature pumps. Set speeds and Aux labels.
Yes
No
Comments
All water features cleaned and tested? (Sheers, slides, waterfalls, deckjets?)
Yes
No
Comments
AUX on pool computer labeled with stickers.
Yes
No
Comments
Label circuit breakers in pool panel.
Yes
No
Comments
Label salt content on top panel. Salt 3.0-3.5
Yes
No
Comments
Check and calibrate pool temp with thermometer in Startup box.
Yes
No
Comments
Put together remaining Startup box. Net, broom, test strips and pool pole.
Yes
No
Comments
Install and test pool sweep. (If plaster pool, do in 10-14 days.)
Yes
No
Comments
Gather all brochures and manuals to one bag. Set on patio/table.
Yes
No
Comments
Pick up and remove all trash and boxes. Including pool sweep and startup box.
Yes
No
Comments
Take a few pictures of the pool from different angles. Post to GROUPME!!!!
Yes
No
Comments
Pool with Spa
Blow out spa lines. (pump on high speed)
Yes
No
Comments
Blow out spa air lines with spa blower while bleeding out lines. Let run for a few minutes to make sure lines are clear before installing niches.
Yes
No
Comments
Install spa niches using Aladdins silicone sealant on gasket.
Yes
No
Comments
Set heater to remote T STAT, and set temps to 104 for pool and spa.
Yes
No
Comments
Bleed the gas line, and test heater. Set 5 degrees above spa temp and run.
Yes
No
Comments
Submit
Powered by